The future development of the hottest polyester bo

2022-09-19
  • Detail

The future development of polyester bottle chips

at present, the supply of polyester for fiber market is seriously oversupplied, and the production is at a loss. At the same time, with the improvement of people's living standards, the consumption of carbonated drinks, mineral water and tea drinks has increased rapidly, and the demand for polyester bottle chips has increased significantly. Many polyester factories have turned their attention to this potential market

from the middle of February this year, the price decline of polyester chips for fiber has accelerated, and the production of large polyester chips will lose more than 800 yuan/ton by the end of April. In sharp contrast to fiber polyester, the profit margin of bottle polyester is increasing. According to the price of PTA and eg delivered to the factory at the end of April this year, the production cost of water bottle tablets is 7500 ~ 7800 yuan/ton, the profit level is 2500 ~ 4000 yuan/ton, and the average profit level of the industry is about 3000 yuan/ton. Carbonated beverage bottle tablets and hot filling bottle tablets are more expensive and profitable. Compared with polyester for fiber, the investment heat of polyester bottle chips formed late, and there is still a large gap at present. Bottle polyester has developed slowly in the past two years. Its annual production capacity has increased by only 40000 tons since 1999. At present, the domestic annual production capacity is only 410000 tons. In recent years, the development of China's beverage industry has been growing at an average annual rate of 20%. In 1999, the demand for polyester bottle chips in China's beverage industry, liquor industry and edible oil industry was about 450000 tons, increased to 550000 tons in 2000, and increased to 650000 tons in 2001, with a gap of about 240000 tons. In terms of domestic polyester bottle chip capacity, the market is seriously in short supply, and its use will continue to expand. At present, polyester beer bottles are more developed to replace glass bottles. In 2000, China's beer consumption reached 23.13 million tons. If 10% ~ 15% of beer bottles were converted to polyester bottles, 3.1 billion ~ 5 billion polyester beer bottles would be needed, and the demand for polyester bottle chips would increase by 225000 ~ 375000 tons. Due to the shortcomings of glass bottles such as high quality and explosion, it is a development trend for polyester bottles to gradually enter the beer bottle market. Of course, the use of polyester bottles in beer packaging is still in the stage of research and improvement, and has not been widely promoted. Potential risks should be considered while investing

it is estimated that the demand for bottle polyester in China will rise to 800000 tons in 2002. Therefore, enterprises in the polyester industry are optimistic about the production of bottle polyester, and their willingness to invest has increased significantly, which has led to the investment enthusiasm of polyester enterprises partially turning to polyester bottle chips, and turning to the production of polyester bottle chips through the transformation of fiber polyester devices. At the same time, the beverage industry and wine industry also began to invest in bottle polyester in order to provide self-sufficiency. In order to seize the market first, some weak enterprises only use SSP tackifier. It is the oversupply of fiber polyester, serious losses in the industry, and the current shortage of bottle polyester, rich profits, and rapid demand growth, which are optimistic about the future market, so they are launched one after another, forming the current investment fever of bottle polyester

at present, there are 12 bottle polyester chip production enterprises in China, with a total annual production capacity of 404000 tons. From 1995 to 2000, the domestic polyester bottle chip gap was solved by importing. Although there is a certain gap in the polyester bottle chip market, there are many projects under construction, planned to be built and planned to be built, some of which can be put into production in the near future. It is estimated that the production capacity of polyester bottle chips in China will reach more than 1.22 million tons/year by the end of this year. In addition, some small enterprises switched to bottle blanks when the production of fiber polyester was at a loss. These bottle blanks are finally produced into polyester bottle chips after tackifying by township enterprises. Therefore, the capacity under construction (including transformation) and planned to be built will still increase significantly. It is estimated that China's polyester bottle chip production capacity will still be in a high growth period in 2002 and 2003

it is predicted that the domestic market demand for polyester bottle chips will not exceed 800000 tons in 2002. If the polyester technology for beer bottles cannot be greatly expanded, it will be very difficult for China's annual demand for polyester for bottles to exceed 1million tons in 2003. At present, although the polyester technology for beer bottles has been industrialized in Britain, the price of polyester for beer bottles will be expensive due to technical confidentiality, so the use of polyester in beer bottles cannot be popularized in China in recent years. In recent years, if the above projects under construction are put into operation as scheduled, the production capacity of polyester bottle chips will reach more than 1.2 million tons by the end of this year. It is unnecessary to consider that there will be new production capacity in 2002, and the market will be saturated at that time. Therefore, it can be predicted that the oversupply of polyester bottle chip market is not far away, and the polyester bottle chip market will soon be like the fiber polyester market. This is not so much an opportunity for polyester bottle chip investment as a risk

for this reason, we appeal not to turn the flocking of polyester investment into bottle polyester when the fiber polyester is in recession, which will cause excessive investment and disorderly development of bottle polyester, which is not beneficial to the country or enterprises. It is hoped that enterprises will weigh more opportunities and risks when making decisions. Suggestions:

pay attention to the total development and adjust the product structure. Polyester bottle chip investors should be cautious in making decisions, do a good job of market capacity research, and don't blindly turn their eyes to bottle polyester when the fiber polyester is in recession. At present, this kind of vision has caused bottle polyester to embark on the old road of overheating fiber polyester investment, and the excessive supply of bottle polyester is not far off. Even if investment is needed, flexible devices should be considered as much as possible in equipment selection. According to market conditions, polyester for bottle and polyester for fiber can be produced, which will have greater flexibility and greatly reduce investment risk. It is necessary for new enterprises to make a good positioning of product grade. Old enterprises of bottle polyester should adjust the product structure, try to avoid the highly competitive water bottle chip market, and increase product development funds, so that enterprises can obtain a certain market share in hot filling bottles, large capacity bottles, one piece bottles, and polyester for injection and blowing cosmetic bottles with relatively high added value

improving product quality and obtaining coke certification is the life of enterprises, and polyester bottle chip manufacturers are no exception. Quality and quality are the chips for polyester bottle chip manufacturers to participate in the competition, especially when the surplus of polyester bottle chips is not far away, we should pay more attention to the improvement of quality. In the field of polyester bottles and chips, the quality of products depends on their market access certification (the certification of Coca Cola and Pepsi). When the domestic polyester bottle chip market is facing surplus, it is particularly important to prepare for export before the real surplus. Obtaining the certification of Coca Cola and Pepsi is also the most effective way to prepare for export. Passing the certification of Coca Cola and Pepsi is equivalent to obtaining an export license

while the production capacity of bottle polyester increases, it is necessary to strengthen the quality and health publicity and management of Coca Cola, Pepsi Cola, Wahaha, robust, Nongfu Shanquan and other brand beverages that occupy most of the domestic beverage market. It is required that the polyester bottles used must have reliable quality assurance in terms of transparency, acetaldehyde content and so on. However, in order to reduce the packaging cost, many bottle blowing enterprises and beverage production enterprises do not hesitate to sacrifice people's health. They use a large number of fiber bright polyester chips, polyester bottle chip base materials and imported recycled waste bottle chips with insufficient transparency and low strength, and excessive acetaldehyde content. Therefore, it is suggested that while the production capacity of bottle polyester chips increases rapidly and the price gradually decreases, bottle blowing and beverage enterprises should be vigorously promoted and guided to use polyester for bottles that meet the hygiene standards. At the same time, we call on the national industrial and commercial, health and technical supervision and administration departments to strengthen management to prevent fiber bright polyester chips that fail to meet the hygiene standards from fully combining the process requirements and characteristics, and wholeheartedly provide customers with all-round services and recycle waste bottle chips into the edible polyester bottle Market

appropriately increase R & D investment and pay attention to the development of polyester in the wine packaging market. Wine bottles are a potential big market. Because glass bottles have shortcomings such as high quality, fragile and easy to explode in another state, it is a development trend for polyester bottles to gradually enter the wine bottle market. At present, China's polyester has entered the field of white wine bottle packaging. Although its market share in white wine bottles is still relatively small, it is expected that with the production line of Wuliangye with an annual output of 150000 tons of polyester bottle chips put into operation, the market share of polyester in the field of Baijiu packaging will rise significantly. The beer bottle market is a potential huge polyester consumption market for all kinds of bottles. In the future, polyester bottles will become the protagonist of the beer bottle market. Bottle polyester production enterprises should pay close attention to the development of polyester beer bottle technology, and pay close attention to the development of polyester white wine bottle market consumption tendency

Copyright © 2011 JIN SHI